Jasco Security Camera 45406 User Manual

45406  
Home Monitoring  
Wired Color  
Camera  
User Manual  
For indoor/outdoor use. Do not use in wet locations  
1-800-654-8483  
 
3
PACKAGE CONTENTS  
Please check and identify all the parts before  
proceeding with the installation.  
1. 45406 Wired Color Camera with desktop mount  
2. AC/DC Adapter  
3. Wall Mounting Kit (wall mount, 1 screw, 1 plastic  
anchor, 20 cord clips)  
4. 60’ Camera connection cable (not rated for in-  
wall use.)  
INSTALLING AND VIEWING THE CAMERA  
Before starting the installation, we recommend  
you temporarily connect the camera to your TV to  
help determine the best location for installing the  
camera.  
• The camera will connect to RCA audio/video  
jacks on your TV/VCR/DVR.  
• There are two connection methods shown.  
Choose the best one for your requirements.  
CONNECTION METHOD 1  
To view the 45406 Color Camera picture:  
1. Switch on the TV and set the volume to  
midpoint. Connect power to the 45406 Wired Color  
Camera.  
 
4
TV  
Power  
Video In  
Audio In  
2. Select the AV channel on your TV by pressing  
the button labeled “AV” (sometimes also labeled  
as “Input”, “Mode”, or “Function”) on your TV or its  
remote control. You should now be able to see and  
hear the output from the camera.  
CONNECTION METHOD 2  
If you are using a VCR/DVR with RCA jacks, connect  
the camera as shown on next page:  
To view the 45406 Wired Color Camera picture:  
1. Switch on the TV, the VCR or DVR and set the  
volume to midpoint. Connect the power adapter to  
the camera, and the other end to an AC outlet.  
2. Select the AV channel on your TV by pressing  
the button labeled “AV” (sometimes also labeled  
 
5
TV  
Power  
Audio Video  
In In  
VCR  
Audio  
In  
Video  
In  
Audio Video  
Out Out  
as “Input”, “Mode”, or “Function”) on your TV or its  
remote control. This should be the channel you  
normally use for watching the VCR or DVR. You  
should now be able to see and hear the output from  
the camera.  
WHERE TO POSITION THE CAMERA  
The 45406 Wired Color Camera is suitable for  
indoor or outdoor use. Remember the following  
points when choosing a mounting position:  
• When installing camera outside, mount it in a  
sheltered location such as under an eave.  
• The camera must be positioned so it will not  
point directly into the sun or any bright light,  
as this may damage the camera.  
 
6
• Avoid viewing areas where half the area is  
in bright sunlight and the other half is dark,  
such as the shadow of a building. All types of  
cameras have difficulty in “seeing” with such a  
large light-level variation.  
• The camera will work in low light conditions,  
but it will function better if a light, (such as a  
100W incandescent lamp) is present near the  
camera for good visibility at night.  
• The camera cable may be extended up to  
300 ft. with additional cable (not supplied.)  
Remember this when choosing a location for  
the camera. An additional 60 ft. extension  
cable is available; contact Customer Service at  
800-654-8483.  
COMPLETING THE INSTALLATION  
Once the camera position is chosen, complete the  
installation as follows:  
1. Disconnect the power to the camera.  
2. Attached the camera to the wall as shown.  
-
-
Audio hole  
 
of camera  
indicates bottom  
7
3. The bracket can also be attached to the camera  
in two different ways, choose the method which  
suits you best.  
Ceiling mount  
Desktop mount  
Wall mount  
4. Run the 60’ cable from the TV/VCR/DVR location  
to the camera and reconnect to the camera cable.  
Use the cord clips provided to keep the cable in  
place.  
5. If you disconnected the camera leads from the  
TV/VCR/DVR, reconnect the cable.  
6. Switch on the power to the TV/VCR/DVR.  
7. Select the AV channel on the TV/VCR/DVR to  
which the camera is connected. You should hear  
and see the camera output.  
8. Any slight adjustments can now be made to  
the camera viewing angle by carefully tilting and  
panning the camera head.  
 
8
NOTES ON CABLE INSTALLATION  
• Keep the camera cable away from other cables  
where possible, in order to reduce the risk of  
picture and audio interference.  
• Avoid laying the cable next to any heat sources.  
• If the cable is run along the ground, a protective  
covering must be used to prevent the cable from  
being damaged.  
• Do not run the cable inside walls.  
• Do not pierce, puncture, or cut cable when  
installing.  
If you have any questions or feel the camera  
system is not operating correctly, or you simply  
need additional information, please visit our  
Customer Service Group at 1-800-654-8483.  
SPECIFICATIONS (Subject to change without notice.)  
AC/DC Adapter  
Power supply operating voltage................................................120V 60Hz  
Output voltage...............................................................................................9V DC  
Output current.............................................................................................100mA  
Camera  
Camera operating voltage......................................................................9V DC  
Current consumption..........................................................45mA maximum  
 
9
Camera type..............................................................................color 1/4” CMOS  
Horizontal resolution.....................................................................360 TV lines  
Lens....................................................................................................................5.6mm  
Minimum illumination...................................................................................3 lux  
Video signal output.......................................... NTSC 1 Vp-p into 75 Ohm  
Audio signal output.....................................................2 Vp-p into 47k Ohm  
Operating temperature ................................-10°~+40° C (14° to 104° F)  
Overall size.....................................................................................Diameter: 1.6”  
Pre-connected Cable type...........................................6 conductor cable  
Lead Connectors .............................................................6 pin mini-DIN plug  
60’ Lead Cable type..........................................................6 conductor cable  
Connectors.....................................................................6 pin mini-DIN socket  
WARRANTY  
ONE-YEAR LIMITED WARRANTY: Jasco Products Company  
warrants this product to be free from manufacturing defects  
for a period of one year from the original date of consumer  
purchase. This warranty is limited to the repair or replacement  
of this product only and does not extend to consequential or  
incidental damage to other products that may be used with  
this unit. This warranty is in lieu of all other warranties express  
or implied. Some states do not allow limitations on how long an  
implied warranty lasts or permit the exclusion or limitation of  
incidental or consequential damages, so the above limitations  
may not apply to you. This warranty gives you specific rights,  
and you may also have other rights which vary from state to  
state. If unit should prove defective within the warranty period,  
return prepaid with dated proof of purchase to:  
Jasco Products Company  
10 E. Memorial Road, Oklahoma City, OK 73114  
 
10  
WARNING  
Risk of fire and shock  
• Only use the supplied cUL listed AC to DC adapter.  
• The supplied adapter is for indoor use only.  
• Do not run the camera cable inside walls; when securing the  
cable, do not cut or puncture  
• Do not use in wet locations  
FCC STATEMENT  
NOTE: This equipment has been tested and found to comply  
with the limits for a Class B digital device, pursuant to Part  
15 of the FCC Rules. These limits are designed to provide  
reasonable protection against harmful interference in a  
residential installation. This equipment generates, uses and  
can radiate radio frequency energy and, if not installed and  
used in accordance with the instructions, may cause harmful  
interference to radio communications. However, there is no  
guarantee that interference will not occur in a particular  
installation. If this equipment does cause harmful interference  
to radio or television reception, which can be determined by  
turning the equipment off and on, the user is encouraged to try  
to correct the interference by one or more of the following  
measures:  
- Reorient or relocate the receiving antenna.  
- Increase the separation between the equipment and receiver.  
- Connect the equipment into an outlet on a circuit different  
from that to which the receiver is connected.  
- Consult the dealer or an experienced radio/TV technician  
for help.  
 
11  
Made in China  
is a trademark of General Electric Company  
and is used under license to Jasco Products Company LLC,  
10 E. Memorial Road, Oklahoma City, OK 73114  
 

Indesit Cooktop PI640 TC GB User Manual
Insignia Portable DVD Player NS CAPDVD7 User Manual
Intel Medical Alarms 273246 002 User Manual
Ironman Fitness Bicycle Ironman 112M User Manual
Jacuzzi Swimming Pool Vacuum GA95 User Manual
JVC DVD Recorder KD NX901 User Manual
JVC DVR VR N1600 User Manual
Kenmore Refrigerator 7957104 User Manual
Kenwood Car Stereo System TM 732E User Manual
KitchenAid Dishwasher KUDD03DTPA10 User Manual