Jasco Mouse 98505 User Manual

98505  
Wireless Optical  
Presentation Mouse  
Instruction Manual  
For technical support contact Jasco Products at 1-800-654-8483 or  
 
Battery Installation  
1. Press the battery release button on top of the mouse.  
2. The battery door will open.  
3. Insert 1 AA battery, being sure to match the polarity  
of the battery with the polarity markings inside the  
battery compartment.  
4. Close the battery door.  
Mouse Installation  
1. Slide the USB Receiver out of the bottom of the mouse.  
2. Once the receiver has been removed, the Battery Meter  
will light up.  
LED  
Green Light = battery life is good.  
Red Light (Blinking slowly) = battery is low.  
Red Light (Blinking rapidly) = change battery.  
3. Insert the USB receiver into an available USB port.  
The receiver has an LED on the top.  
Green Light on Receiver = Mouse movement.  
Red Light on Receiver = Low battery.  
4. Please refer to page 6 of this manual for the  
Mouse Suite Installation.  
Battery Light  
3
 
Reconnecting the Mouse to the Receiver  
This mouse will usually automatically connect to the receiver. If needed,  
you can connect the mouse to the receiver by following these steps.  
1. Press the button on top of the receiver. The LED will light up on  
the receiver.  
2. Press the button on the bottom of the mouse. It is located where the  
receiver is stored.  
3. The LED on the receiver will blink and you are finished.  
Storing the Receiver  
To help conserve battery and increase portability you  
may store the receiver under the mouse. To do this,  
simply unplug the receiver from your USB slot and  
place it in the designed position on the bottom of the  
mouse. Once the receiver is correctly in place, the power  
will automatically shut off.  
Using the Laptop Clip  
Your mouse is equipped with the Laptop Clip. This is used for easy storage  
of the mouse while on the go with your laptop. To use this clip, simply insert  
the clip on the bottom of the mouse then place your mouse into the modem  
slot on your laptop. Please ensure that your modem slot is not in use before  
attaching the storage clip.  
4
 
Presentation Mode  
To switch your mouse to  
Presentation Mode please  
slide the switch on the bottom  
of the mouse towards the  
presentation icon.  
Presentation Mode Functions  
Your mouse is equipped with a variety of functions to help assist you with  
any presentation. Please refer to the diagram above for a short description  
of the button functions.  
!CAUTION!  
Do not aim or look into the integrated laser pointer. Direct exposure to  
laser will cause damage to the eye.  
5
 
Mouse Suite Software (for Windows® Vista, XP & 2000 only)  
The Mouse Suite is a software program with many features that give  
amazing functionality to your GE mouse. Here is a brief overview.  
Installation Procedure  
1. Insert the Installation CD into the computer CD drive.  
2. Run the file named “Setup”.  
3. Follow the instructions on the screen.  
4. Click Finish when completed.  
Buttons Tab  
From this screen you can set the function of each button on your mouse.  
There are over 33 functions to choose from. To specify the function of each  
button follow these steps:  
6
 
1. Select the button you  
want from the Button  
drop down menu.  
2. Next select the function  
you want by using the  
Function drop down menu.  
3. After you have selected  
the features you want  
click apply at the bottom  
of your screen. You may  
change these features at  
any time.  
You may also check your battery life from this screen. The battery indicator  
is located on the right side of the window.  
Magnifier Function  
This feature allows you to  
use the scroll button as a  
magnifier.  
To enable this feature,  
simply check the box labeled  
“Magnifier” and click Apply.  
Press the middle scroll button  
to activate the magnifier.  
To make the magnifier size  
taller, press and hold the  
scroll button again and move  
the mouse up or down. To make the magnifier size wider, move the mouse  
right or left.  
7
 
Double-Click Tab  
This screen allows you to  
set the double-click speed  
of your mouse. Use the  
slider to set the desired  
speed. You must click Apply  
to update any changes.  
Orientation Tab  
This feature allows you to  
set the orientation of the  
mouse while finding the  
most comfortable position  
to hold the mouse. Please  
follow the directions on the  
screen to set the orientation.  
8
 
Wheel Tab  
This screen allows you to  
select different wheel  
operations. You may also  
select vertical scrolling  
speed as well as horizontal  
scrolling speed. If you would  
like to reverse the scrolling  
direction of the mouse,  
please check the box  
labeled Reverse Scrolling  
Direction.  
Pointer Utility Tab  
From this screen you can  
select different functions  
for the pointer.  
Pointer Wrap  
The pointer wrap feature  
allows the pointer to go in  
one side of the screen and  
come out of the opposite  
side. This works at both  
sides of the screen as well  
as top and bottom. This allows easier and more functional mouse  
navigation with less wrist and arm movement.  
9
 
Slow Motion  
This feature allows the pointer to move in slow motion by pressing the Shift  
key. This will help the precision of the pointer.  
X-Focus  
This feature allows you to make an inactive window active by simply moving  
the pointer over the title bar.  
Troubleshooting  
• Mouse does not work properly  
- Check the battery life on your mouse. If it is low please install new batteries.  
- Reconnect your mouse to the receiver. Press the link button on the receiver.  
Press the link button on the bottom of your mouse. (page 4)  
• Mouse does not move on screen.  
- Reconnect your mouse to the receiver.  
- Change the batteries on your mouse.  
- Make sure that your USB receiver is completely plugged into the  
computer’s USB port.  
Questions? Please call 1-800-654-8483 (option #4)  
Monday—Friday, 9:00 am—5:00 pm CST.  
10  
 
Five Year Limited Warranty  
Jasco Products Company warrants this product to be free from  
manufacturing defects for a period of five years from the original date of  
consumer purchase. This warranty is limited to the repair or replacement  
of this product only and does not extend to consequential or incidental  
damage to other products that may be used with this unit. This warranty is  
in lieu of all other warranties express or implied. Some states do not allow  
limitations on how long an implied warranty lasts or permit the exclusion or  
limitation of incidental or consequential damages, so the above limitations  
may not apply to you. This warranty gives you specific rights, and you may  
also have other rights which vary from state to state. If unit should prove  
defective within the warranty period, return prepaid with dated proof of  
purchase to:  
Jasco Products Company  
10 East Memorial Dr  
Oklahoma City, OK 73114  
FCC Statement  
Notice: Federal Communications Commission (FCC) requirements, Part 15  
This equipment has been tested and found to comply with the limits for a  
class B digital device, pursuant to part 15 of the FCC Rules. These limits are  
designed to provide reasonable protection against harmful interference in  
a residential installation. This equipment generates, uses and can radiate  
radio frequency energy and, if not installed and used in accordance with  
the instructions, may cause harmful interference to radio communications.  
However, there is no guarantee that interference will not occur in a  
particular installation. If this equipment does cause harmful interference  
to radio or television reception, which can be determined by turning  
the equipment off and on, the user is encouraged to try to correct the  
interference by one or more of the following measures:  
11  
 
• Reorient or relocate the receiving antenna.  
• Increase the separation between the equipment and receiver.  
• Connect the equipment into an outlet on a circuit different from that  
to which the receiver is connected.  
• Consult the dealer or an experienced radio/TV technician for help.  
CAUTION: Any changes of modifications not expressly approved by  
the grantee of this device could void the users authority to operate the  
equipment. This device complies with Part 15 of the FCC Rules. Operation is  
subject to the following two conditions: (1) this device may not cause harmful  
interference, and (2) this device must accept any interference received,  
including interference that may cause undesired operation.  
FDA Notice  
This product complies with DHHS Rules 21CFR Chapter I, Sub chapter J.  
This product has been designed and manufactured according to IEC60825-1  
on the safety label of laser product.  
CLASS 2 LASER  
Class 2 Laser Product  
It is recommended not to point directly in the eye or any other optical device.  
Distributed for GE  
by Jasco Products Company  
311 N.W. 122nd Street, Oklahoma City, OK 73114  
12  
 

Intel Laptop fortran 80 User Manual
iSimple Automobile Accessories PGHHD2C User Manual
Jacuzzi Plumbing Product BM43000 User Manual
John Deere Electric Heater AC 100LP User Manual
JVC Digital Camera GR DV33 User Manual
JVC DVD Recorder DR M70SU User Manual
Kenmore Blender 10090001 User Manual
Kidde Smoke Alarm RF SM ACDC User Manual
KitchenAid Dishwasher KUDE70FVSS0 User Manual
Kodak All in One Printer ESP 5200 Series User Manual